ＥＰ Concept SR expelimental works

It is good idea or useless?

Stabiliser bar reinforcement

Flame / Elevator linkage improvement

Change metal ball

Cutoff normal plastic ball.
Make a hole with 1.5mm drill at center of ball.
Put metal ball on with 2mm screw.
Finish! It is easy.

Swashplate idea

Resolve Swashplate housing, and shave lower ( like this picture ). Surface to bearing.
Make a hole at these point (1.5mm) ( or near size of inch )
Rut together with 2mm bolts. (with wasshar)
Finish!

Please check your Swashplate !!

Rudder Servo Mount

Stainless mast

Antena holder for SR's skid

　Schwizer 300 ( EP-Concept SR )

Flame stiffner

My EP Concept sometimes cause vivration at high speed flight. I think this flame stiffner for hardner flames and hold motor tightly.

This is some of one way. Another way of stiffner are many.
If you have difficulty of useless vivration, Let's think flame stiffner.

Tailpitch slider center hub

Shave 8mm blass shaft to fit in normal slider's ball bearings, and make flange at end. Length 12mm.
At another side of end,6mm pitch dise.
Center of slider, make 3.8mm hole,and shape 4mm with straightreemer.
Aluminium ring,tup 6mm,and thickness 3mm.

previous page

Last updated 1999/02/02
(C) 1998-1999 p-bear@ba2.so-net.ne.jp